PMASS

From VASP Wiki
Revision as of 22:43, 9 November 2023 by Singraber (talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

PMASS = [Real]
Default: PMASS = 1000 

Description: PMASS assigns a fictitious mass (in amu) to the lattice degrees-of-freedom in case of Parrinello-Rahman dynamics (in case VASP was compiled with -Dtbdyn).


When running NpT simulations with a Langevin thermostat[1] (MDALGO=3), using the method of Parrinello and Rahman,[2][3] a fictitious mass (in amu) for the lattice degrees-of-freedom has to be assigned using the PMASS tag. The friction coefficient for lattice degrees-of-freedom have to be specified (in ps-1) by means of the LANGEVIN_GAMMA_L tag.

The friction coefficients γ for the atomic degrees-of-freedom are specified using the LANGEVIN_GAMMA tag.

The optimal setting for PMASS depends very much on the particular system at hand and can be considered as a compromise between two opposing factors: too large values lead to very slow variation of lattice degrees of freedom (and hence the sampling becomes inefficient) while too small value can lead to too large geometric changes in an MD step and hence may cause numerical problems. We strongly recommend to make careful tests with various settings before performing the production run.

Related tags and articles

LANGEVIN_GAMMA_L, LANGEVIN_GAMMA, MDALGO

References

  1. M. P. Allen and D. J. Tildesley, Computer simulation of liquids, Oxford university press: New York, 1991.
  2. M. Parrinello and A. Rahman, Phys. Rev. Lett. 45, 1196 (1980).
  3. M. Parrinello and A. Rahman, J. Appl. Phys. 52, 7182 (1981).

Examples that use this tag